​
All available with free delivery. If collected direct from Angelkoi and Aquatics you will receive 1x Pure Pond Bomb
Now available in Granite or Green
Evolution Eazypod add new eazypod auto
A compact member of the Nexus family, the EazyPod is a mechanical and biological filter system for garden ponds up to 20,000 litres or Koi ponds up to 10,000 litres. The EazyPod utilises static K1 Media, which provides enhanced biological benefits, even when using the EazyPod solely as a mechanical waste filter.
​
The EazyPod is available in grey or green colours and also can be supplied as an EazyPodAir, with an Air Pump 70.
​
-
Mechanical and biological filtration.
-
Very easy to install and operate.
-
Quick and easy cleaning cycle.
-
Works equally well pump or gravity fed.
-
Ideal as a filter on a quarantine system.
-
Also ideal for use as a pre-filter, polisher or on a skimmer line.
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
​
Specifications
Manuals
Dimensions
How the Eazypod Works
Water from the pond enters the EazyPod Complete via the inlet, then flows around the circumference of the outer chamber of the EazyPod, passing through the stainless steel grill causing many of the larger solids to be filtered out and settle in the base of the outer chamber. This is the first stage of mechanical filtration.
​
As water enters the central chamber, through the stainless steel grill, the fine smaller solids become trapped in the mass of K1 Media. Bio-films build up on the protected surface area within each piece of media, allowing biological filtration to take place.
After passing through the K1 Media, the clean water then rises and overflows into the inner return pipe and flows back to the pond via the outlet.
​
The EazyPod is incredibly simple to clean. An airpump is needed for cleaning which agitates the K1 Media to free up any debris and waste that has built up within the filter.
​
EazyPodAir models are supplied with a 70 litre per minute air pump and accessory kit.
Eazypod Complete Layout
Installation
EazyPod filters can be installed on PUMP FED or GRAVITY FED set-ups. In all circumstances the EazyPod needs to be supported evenly on a level base (a paving flag is ideal). Failure to do so could cause damage when it is full of water. It should be a minimum of 600mm x 600mm, to allow easy access to your valves and for maintenance purposes.
Gravity Fed Set-Ups
By this we mean that your pump is going to be used to return the filtered water to the pond and therefore your filter will be supplied by gravity via a larger diameter pipe. In this situation the water level in the filter will be at the same level as the pond.
Pump Fed Set-Ups
By this we mean that if your pump is going to be used to supply the water to the filter, and the filtered water then returns back into your pond via gravity, i.e. down a waterfall, or through a large diameter pipe, this is referred to as PUMP FED(i.e. the water is fed to the filter using a pump).
